| Uploader: | Femi |
| Date Added: | 18 June 2009 |
| File Size: | 8.74 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 66843 |
| Price: | Free* [*Free Regsitration Required] |
The next screen shows a list of disks that can be added to a volume. The Device Properties screen shown below displays information about a specific device. Sets the default value for synchronous and wide negotiations with specified devices. Follow these steps to create a RAID 0 volume on an adapter that does not currently have a volume hpst.
The master boot records MBR of other disks in the array are deleted. In the Configuration Utility, select an adapter from the Adapter List. Note - When activating two arrays typically after a motherboard replacement the hkst of the second array is shown as "degraded" according to the LSI BIOS as it waits to sync. Reset error counts for all Phys. Indicates the specific family of LSI Logic host bus adapters. Indicates the relative boot order 0 to 3 of an adapter.
LSI Fusiion provides the device drivers for various operating environments.
This item can be used to ignore a device scwi to decrease boot time by disabling the inquiry of unused SCSI identifiers. Many thanks to them for good work!
SCSI BIOS Configuration Utility
While the cursor is on the Device Identifier, you can perform the following actions:. Note - Even though multiple volumes can be created, the hotspare is a global hotspare. The Device Properties screen provides viewing and updating of individual device settings for an adapter.
Note - Once a volume has been deleted, it cannot be recovered. There are several limitations when creating a RAID 0 volume:. The array already has a hotspare. Alternate CHS Mapping utilizes an alternate, possibly less-efficient mapping that might be required if a device is moved between adapters from different vendors. Staggered spinups balance the total electrical current load on the system during boot.
Indicates the SCSI identifier of an adapter [] or []. If you keep the existing data, this is called a migration.
LSI Fusion MPT SAS
Are you sure you want to reset Phy error counts? Provides static information text, which is typically the product hoxt and version. This can increase storage capacity and performance by combining multiple disks into one logical volume. The metadata stored on the disk drives contains sufficient information to restore and reactivate the RAID volumes in case the NVRAM is lost for example, when the motherboard is replaced.
The Exit screen is shown below.
Chapter 4. Message-based devices
You might decide to alter these default values if there is a conflict between device settings or to optimize system performance. Since time-outs provide a safeguard hkst allows the system to recover if an operation fails, it is recommended to use a value greater than zero. The screens in the RAID configuration and management area are:. There are several limitations when creating a RAID 1 volume:.
Some options on the Exit screen might be grayed out, indicating that they are not available at this time. Indicates whether to allow a device to disconnect during SCSI operations. Disk is too small to mirror existing data. This field is used to delete the currently displayed RAID array. The size of the array, in Mbytes.
Comments
Post a Comment